A national study has found that nearly two-thirds of fire doors in social housing across England don't meet the legal minimum standard. The inspection data reveals the gap between obligation and reality is even wider than the headlines suggest.
Three years after fire door inspections became mandatory, a nine-month study using Freedom of Information data from most local authorities in England has revealed a worrying finding for those managing residential blocks. Sixty-five percent of social housing fire doors fail to meet the FD30 fire-resistance standard, the legal minimum established over thirty years ago. This is not a new, more stringent standard that landlords are lagging behind; it is the baseline, and the majority of doors fall short.
What makes the inspection data difficult to justify is the extent of inaction beneath the headline figure. Only 46% of flat entrance doors have been inspected at least once since the law was enacted. Of the non-compliant doors identified, 63% have not yet been repaired or replaced. Over half of local authorities lack a formal plan to address the failures they've already discovered. These issues aren't due to capacity limits but stem from systems and processes that have not been established.
Fire doors are the most noticeable part of a building's passive fire protection system, but they are just one piece of the broader compartmentation framework. A door that cannot withstand a 30-minute fire is a failure point. Similarly, a damaged intumescent seal around a service penetration, a missing fire stop in a ceiling void, or a duct passing through a compartment wall without adequate protection also compromises safety. Fire protection is not based on a single product; it is a comprehensive system where every component must function properly to ensure overall effectiveness.
65% is a bad number, but it's the 63% of failed doors that still haven't been touched that really gets me. You've found the problem, you know it's there, and you've done nothing about it. That's worse than not looking. We go in, survey the whole compartmentation picture, doors, seals, penetrations, the lot, and we fix what needs fixing. That's the job, simple as that.
